Go to Trading Partner>AS2
Click [Go!] under Create New – AS2 partner or organization
By default Partner is checked, Click [Next]
By default Create New Identity is checked, Click [Next]
Identity Name – Give your AS2 Partner profile an Identity Name. It’s an internal name used by SI.
AS2 Identifier – Use the AS2 Identifier your part sent to you. In our case it is Some_Company
Click [Next]
Profile Name – Enter a name
HTTP Client Adapter – defaults to the out of the box service. You can use it or a custom one.
End Point – Use the end point that your partner give you. In our example it’s http://localhost:63233/as2
Response Timeout (sec) – This timeout is used during the initial connection to your partners side. It may need to be increased if set too low.
SSL – defaults to None. If you are to set up SSL with a partner this is where you would do it…FYI. In our example we are using the default of None.
Now we need to point to the certificate that you recently checked in from your partner.
Click ‘Configure Certificates’ next to Exchange Certificate.
This will open a pop up window that displays all your Trusted Certificates.
Highlight the certificate you want to use under the Available side and click the right arrow -> to move it to the Certificates Used side.
Click [Save]
Repeat the above steps for the Signing Certificate as well.
Check MDN Receipt if you are planning on passing MDN’s to your partner. In our example, we are.
Click [Next]
Delivery Mode – Referring to the MDN defaults to Synchronous.
Click [Next] and [Finish].
The AS2 Partner has been created!
You can verify by going to
Trading Partner>AS2
Click [Go!] next to Search Profiles by Identity – ALL
You should see some thing similar to the following:
Click [Return]
You must be logged in to post a comment.